High dynamic range isotope ratio measurements using an analog electron multiplier

Peter Williams, J. Lorincik, K. Franzreb, Richard Hervig

Research output: Contribution to journalArticlepeer-review

Abstract

We have explored measurement and accuracy issues in the use of an electron multiplier detector as a fast analog amplifier rather than in pulse-counting mode. The electron multiplier on a Cameca IMS 3f instrument was modified to allow both analog and digital signals to be recorded simultaneously. The digital signal was picked up on the last dynode and the analog signal was recorded at the anode (operated near ground potential). The digital signal was differentiated to convert the positive pulse at the last dynode to a negative-going signal that could be processed by the digital electronics of the IMS 3f and fed into the pulse counting system. The analog signal was amplified by an operational amplifier with a 106 ohm feedback resistor and the resulting signal was fed into the voltage/frequency convertor that normally processes the electrometer output from the Faraday cup collector. Isotope ratio measurements were explored for negative ion signals of the silicon and sulfur isotopes under Cs+ primary ion bombardment. For 32S and 34S signals of ∼ 3 × 107 and ∼ 1.3 × 106 counts/s respectively and 1 s counting times for each isotope, the standard deviations of the means of 140 ratio measurements averaged 0.3 per mil. Measurements on two sulfide samples with isotope ratios previously determined to differ by 13.6 per mil were within 1.2 ± 0.5 per mil of the previous difference value. Sources of residual error are discussed.

Original languageEnglish (US)
Pages (from-to)549-552
Number of pages4
JournalSurface and Interface Analysis
Volume45
Issue number1
DOIs
StatePublished - Jan 2013

Keywords

  • analog
  • dynamic range
  • electron multiplier
  • isotope ratios

ASJC Scopus subject areas

  • Chemistry(all)
  • Condensed Matter Physics
  • Surfaces and Interfaces
  • Surfaces, Coatings and Films
  • Materials Chemistry

Fingerprint

Dive into the research topics of 'High dynamic range isotope ratio measurements using an analog electron multiplier'. Together they form a unique fingerprint.

Cite this