Heat transfer enhancement of internal laminar flows using additively manufactured static mixers

Beomjin Kwon, Leon Liebenberg, Anthony M. Jacobi, William P. King

Research output: Contribution to journalArticlepeer-review

42 Scopus citations

Abstract

This paper investigates heat transfer enhancement by means of additively manufactured static mixers during liquid water cooling of a horizontal, heated flat plate. The static mixers disrupt the thermal boundary layer and induce mixing, resulting in an increased heat transfer rate of about 2X larger than flows without mixers. Simulations of the flows provided insights into the flows near the mixers, and guided selection of specific mixer geometries. The mixers were fabricated directly into the flow channels using additive manufacturing and then assembled onto the heated plate. Two types of mixing structures were analyzed: twisted tape structures that are similar to conventional static mixers; and novel chevron-shaped offset wing structures. Heat transfer performance was measured for liquid water (510 ≤ Re ≤ 1366) cooling the heated section with convective heat flux ranging between 0.1 and 0.8 W/cm2. This work demonstrates the potential of additive manufacturing to enable novel flow geometries that can enhance convection heat transfer whilst minimizing pressure drop penalties and volumes.

Original languageEnglish (US)
Pages (from-to)292-300
Number of pages9
JournalInternational Journal of Heat and Mass Transfer
Volume137
DOIs
StatePublished - Jul 2019

Keywords

  • Additive manufacturing
  • Convection heat transfer
  • Heat transfer enhancement
  • Static mixer

ASJC Scopus subject areas

  • Condensed Matter Physics
  • Mechanical Engineering
  • Fluid Flow and Transfer Processes

Fingerprint

Dive into the research topics of 'Heat transfer enhancement of internal laminar flows using additively manufactured static mixers'. Together they form a unique fingerprint.

Cite this