Chemical and physical changes of microplastics during sterilization by chlorination

Varun P. Kelkar, Charles B. Rolsky, Anupum Pant, Matthew Green, Sefaattin Tongay, Rolf Halden

Research output: Contribution to journalArticle

Abstract

Wastewater treatment plants are known to release microplastics that have been detected in aquatic and terrestrial organisms constituting part of the human diet. Chlorination of wastewater-borne microplastics was hypothesized to induce chemical and physical changes detectable by Raman spectroscopy and differential scanning calorimetry (DSC). In the laboratory, virgin plastics (∼0.05 × 2 × 2 mm) were exposed to differing sterilization conditions representative of dosages used in the disinfection of drinking water, wastewater, and heavily contaminated surfaces. Polypropylene (PP) was most resistant to chlorination, followed by high density polyethylene (HDPE) and polystyrene (PS). Polystyrene showed degradation, indicated by changes in Raman peak widths, at concentration-time regimes (CT values) as low as 75 mg min/L, whereas HDPE and PP remained unaltered even at chlorine doses characteristic of wastewater disinfection (150 mg min/L). However, HDPE and PS were not completely resistant to oxidative attack by chlorination. Under extremely harsh conditions, shifts in Raman peaks and the formation of new bonds were observed. These results show that plastics commonly used in consumer products can be chemically altered, some even under conditions prevailing during wastewater treatment. Changes in polymer properties, observed for HDPE and PP under extreme exposure conditions only, are predicted to alter the risk microplastics pose to aquatic and terrestrial biota, since an increase in carbon-chlorine (C–Cl) bonds is known to increase toxicity, rendering the polymers more hydrophobic and thus more prone to adsorb, accumulate, and transport harmful persistent pollutants to biota in both aquatic and terrestrial environments.

Original languageEnglish (US)
Article number114871
JournalWater Research
DOIs
StatePublished - Oct 15 2019

Fingerprint

Chlorination
High density polyethylenes
chlorination
Polypropylenes
Polystyrenes
Wastewater
Disinfection
wastewater
Wastewater treatment
disinfection
Chlorine
chlorine
biota
polymer
plastic
Plastics
Consumer products
terrestrial environment
calorimetry
Raman spectroscopy

Keywords

  • Chlorination
  • Degradation
  • Microplastics
  • Raman spectroscopy
  • Wastewater treatment plants

ASJC Scopus subject areas

  • Ecological Modeling
  • Water Science and Technology
  • Waste Management and Disposal
  • Pollution

Cite this

Chemical and physical changes of microplastics during sterilization by chlorination. / Kelkar, Varun P.; Rolsky, Charles B.; Pant, Anupum; Green, Matthew; Tongay, Sefaattin; Halden, Rolf.

In: Water Research, 15.10.2019.

Research output: Contribution to journalArticle

@article{61f1de9cfe8b497e85c1b75ea21f8df2,
title = "Chemical and physical changes of microplastics during sterilization by chlorination",
abstract = "Wastewater treatment plants are known to release microplastics that have been detected in aquatic and terrestrial organisms constituting part of the human diet. Chlorination of wastewater-borne microplastics was hypothesized to induce chemical and physical changes detectable by Raman spectroscopy and differential scanning calorimetry (DSC). In the laboratory, virgin plastics (∼0.05 × 2 × 2 mm) were exposed to differing sterilization conditions representative of dosages used in the disinfection of drinking water, wastewater, and heavily contaminated surfaces. Polypropylene (PP) was most resistant to chlorination, followed by high density polyethylene (HDPE) and polystyrene (PS). Polystyrene showed degradation, indicated by changes in Raman peak widths, at concentration-time regimes (CT values) as low as 75 mg min/L, whereas HDPE and PP remained unaltered even at chlorine doses characteristic of wastewater disinfection (150 mg min/L). However, HDPE and PS were not completely resistant to oxidative attack by chlorination. Under extremely harsh conditions, shifts in Raman peaks and the formation of new bonds were observed. These results show that plastics commonly used in consumer products can be chemically altered, some even under conditions prevailing during wastewater treatment. Changes in polymer properties, observed for HDPE and PP under extreme exposure conditions only, are predicted to alter the risk microplastics pose to aquatic and terrestrial biota, since an increase in carbon-chlorine (C–Cl) bonds is known to increase toxicity, rendering the polymers more hydrophobic and thus more prone to adsorb, accumulate, and transport harmful persistent pollutants to biota in both aquatic and terrestrial environments.",
keywords = "Chlorination, Degradation, Microplastics, Raman spectroscopy, Wastewater treatment plants",
author = "Kelkar, {Varun P.} and Rolsky, {Charles B.} and Anupum Pant and Matthew Green and Sefaattin Tongay and Rolf Halden",
year = "2019",
month = "10",
day = "15",
doi = "10.1016/j.watres.2019.114871",
language = "English (US)",
journal = "Water Research",
issn = "0043-1354",
publisher = "Elsevier Limited",

}

TY - JOUR

T1 - Chemical and physical changes of microplastics during sterilization by chlorination

AU - Kelkar, Varun P.

AU - Rolsky, Charles B.

AU - Pant, Anupum

AU - Green, Matthew

AU - Tongay, Sefaattin

AU - Halden, Rolf

PY - 2019/10/15

Y1 - 2019/10/15

N2 - Wastewater treatment plants are known to release microplastics that have been detected in aquatic and terrestrial organisms constituting part of the human diet. Chlorination of wastewater-borne microplastics was hypothesized to induce chemical and physical changes detectable by Raman spectroscopy and differential scanning calorimetry (DSC). In the laboratory, virgin plastics (∼0.05 × 2 × 2 mm) were exposed to differing sterilization conditions representative of dosages used in the disinfection of drinking water, wastewater, and heavily contaminated surfaces. Polypropylene (PP) was most resistant to chlorination, followed by high density polyethylene (HDPE) and polystyrene (PS). Polystyrene showed degradation, indicated by changes in Raman peak widths, at concentration-time regimes (CT values) as low as 75 mg min/L, whereas HDPE and PP remained unaltered even at chlorine doses characteristic of wastewater disinfection (150 mg min/L). However, HDPE and PS were not completely resistant to oxidative attack by chlorination. Under extremely harsh conditions, shifts in Raman peaks and the formation of new bonds were observed. These results show that plastics commonly used in consumer products can be chemically altered, some even under conditions prevailing during wastewater treatment. Changes in polymer properties, observed for HDPE and PP under extreme exposure conditions only, are predicted to alter the risk microplastics pose to aquatic and terrestrial biota, since an increase in carbon-chlorine (C–Cl) bonds is known to increase toxicity, rendering the polymers more hydrophobic and thus more prone to adsorb, accumulate, and transport harmful persistent pollutants to biota in both aquatic and terrestrial environments.

AB - Wastewater treatment plants are known to release microplastics that have been detected in aquatic and terrestrial organisms constituting part of the human diet. Chlorination of wastewater-borne microplastics was hypothesized to induce chemical and physical changes detectable by Raman spectroscopy and differential scanning calorimetry (DSC). In the laboratory, virgin plastics (∼0.05 × 2 × 2 mm) were exposed to differing sterilization conditions representative of dosages used in the disinfection of drinking water, wastewater, and heavily contaminated surfaces. Polypropylene (PP) was most resistant to chlorination, followed by high density polyethylene (HDPE) and polystyrene (PS). Polystyrene showed degradation, indicated by changes in Raman peak widths, at concentration-time regimes (CT values) as low as 75 mg min/L, whereas HDPE and PP remained unaltered even at chlorine doses characteristic of wastewater disinfection (150 mg min/L). However, HDPE and PS were not completely resistant to oxidative attack by chlorination. Under extremely harsh conditions, shifts in Raman peaks and the formation of new bonds were observed. These results show that plastics commonly used in consumer products can be chemically altered, some even under conditions prevailing during wastewater treatment. Changes in polymer properties, observed for HDPE and PP under extreme exposure conditions only, are predicted to alter the risk microplastics pose to aquatic and terrestrial biota, since an increase in carbon-chlorine (C–Cl) bonds is known to increase toxicity, rendering the polymers more hydrophobic and thus more prone to adsorb, accumulate, and transport harmful persistent pollutants to biota in both aquatic and terrestrial environments.

KW - Chlorination

KW - Degradation

KW - Microplastics

KW - Raman spectroscopy

KW - Wastewater treatment plants

UR - http://www.scopus.com/inward/record.url?scp=85069703084&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=85069703084&partnerID=8YFLogxK

U2 - 10.1016/j.watres.2019.114871

DO - 10.1016/j.watres.2019.114871

M3 - Article

JO - Water Research

JF - Water Research

SN - 0043-1354

M1 - 114871

ER -