Anisotropic behavior of single grain CU6SN5 intermetallic

Soud Farhan Choudhury, Leila Ladani

Research output: Contribution to conferencePaperpeer-review

Abstract

Intermetallic (IMC) layers (Cu6Sn5 and Cu3Sn) are an essential component of a solder joint for good metallurgical bonding. However, the mechanical and physical properties of IMC layers differ significantly from the solder and substrate, and excessive IMC layers can lower the reliability of solder joints due to their brittle nature. Moreover, continuous miniaturization of packages and joints has increased the volume fraction of IMCs to a point where smaller joints could be completely composed of IMCs. Further miniaturization of joints may result in statistical grain size effects. One of the most common types of IMCs in microelectronic joints is Cu6Sn5, which is formed in a variety of bonding materials with different compositions of Sn, Cu, and Ag. Due to its large percentage of volume in solder joint; to predict the reliability of micro solder joints, it is necessary to characterize single crystal Cu6Sn5 IMC completely. This study reports the information on grain growth orientation and elasticplastic properties such as young's modulus, hardness, yield strength and strain hardening exponent of single grain of Cu6Sn5 in Sn-3.5Ag/Cu solder alloy system. IMCs materials were grown using reflow process using an experiment in which the time and temperature of reflow process was varied. Electron backscatter diffraction (EBSD) analysis was conducted after the reflow to measure the grain size and determine the preferred grain orientation. It was found that the growth orientation is in the orientation of the c-axis. Nanoindentation was carried out in 4 individual grains with different crystallographic orientation along normal to the growth axis to determine the elastic properties of Cu6Sn5 single crystal. Plastic properties were predicted using the nanoindentation results and Dao reverse analysis model. The results indicate that the hardness for Cu6Sn5 grains with different orientation along normal to growth axis is statistically indistinguishable. Lower elastic modulus was observed for a grain with [010] direction parallel to the loading direction. Yield strength of a grain with (001) plane parallel to the loading direction was slightly lower than other grain orientations. Overall, the experimental results obtained were found to be within the range shown in the literature.

Original languageEnglish (US)
DOIs
StatePublished - 2014
Externally publishedYes
EventASME 2014 International Mechanical Engineering Congress and Exposition, IMECE 2014 - Montreal, Canada
Duration: Nov 14 2014Nov 20 2014

Other

OtherASME 2014 International Mechanical Engineering Congress and Exposition, IMECE 2014
CountryCanada
CityMontreal
Period11/14/1411/20/14

ASJC Scopus subject areas

  • Mechanical Engineering

Fingerprint Dive into the research topics of 'Anisotropic behavior of single grain CU<sub>6</sub>SN<sub>5</sub> intermetallic'. Together they form a unique fingerprint.

Cite this